Shijiazhuang great production of 400 tons of powder metallurgy S imported hydraulic briquetting machine. Powder compact machine is a medium-sized briquetting machine equipment. Briquetting machine is suitable for all kinds of powder materials, powder, powder, scrap, waste pressed into square type, rectangle, polygon, bar, pillow, Bread, rhombus shapes of different specifications, sizes self-regulation. The series pressure vary in how much and finished feed compactness can be adjusted. Also based on customer requirements, using domestic and imported hydraulic, can be equipped with automatic feeding, weighing and other devices. Automatic hydraulic powder molding machine, four-post structure hydraulic machine is mainly used to structure-based powder metallurgy, mechanical parts production, but also for iron, copper, aluminum powder, stainless steel powder, fine ceramics, electronic ceramics, graphite and hard syngas gold molding products. Pressing technique and finishing technology has reached the international advanced level. My company can provide the raw material formulation, pressing, heat treatment and finishing a full set of technology. This press uses advanced mechanical, electrical, hydraulic and pneumatic control, with automatic feeding device, floating pressing, molding density of the article has been effectively controlled, the protective stripping and general stripping and other methods to choose from, the hydraulic system using advanced portfolio superimposed valve block, hydraulic machine to ensure continuous, frequent stability; mechanical stopper positioning loading, forming and releasing three positions and stepless adjustment mechanism to determine the stability of the geometry of adjustable products. With a fluid cooling means. PLC and HMI centralized control, while equipped with a mechanical stopper, to ensure product consistency. Safe operation: 1, do not understand the structure and properties of the machine or operating procedures were not allowed to start the machine; 2, machine operation, maintenance and adjustment should not be mold; 3, when the machine detects a serious oil spill or other abnormalities (eg, action is not reliable, noise, vibration, etc. should) stop to analyze the reasons, trying to exclude, not sick into production: 4, do not overload or exceed the maximum eccentricity of use: 5, shall not exceed the maximum stroke of the slider, the minimum height of the mold is closed not less than 600mm. 6, electrical equipment ground must be solid and reliable: 7, ending a day of work: put the slider to the lowest position.